Data Portal @ linkeddatafragments.org

Matches in DBpedia 2014 for { ?s ?p The SEAT 133 was a small rear-engine car designed and sold by SEAT in Spain from 1974 to 1979. The car used the chassis and engine of the by then defunct Fiat/SEAT 850 and featured a new body in the style of the contemporary, somewhat smaller and only indirectly related Fiat 126.The car was first exhibited at the Barcelona Motor Show in May 1974. Noteworthy at that time was the compression ratio of only 8:1, which permitted the car to run on 85 octane petrol/gasoline. This was still appropriate in Spain, but elsewhere in western Europe even "regular" fuel grades by now generally guaranteed a higher minimum octane rating.The 133's design premise was that it had to be a cheap car both to develop and build. Thus, the final product inherited most of its components from the SEAT 850 (or very closely related Fiat 850). As with the 850, it was a rear-wheel drive, rear-engined car, a layout a that was being replaced by a trend for front-engined, front-wheel drive hatchbacks like the Renault 5 and Fiat's own Fiat 127.The 133 effectively replaced the SEAT 850 and the SEAT 600 both of which had been produced in considerable numbers with around 800,000 of the more venerable 600 built – almost exclusively for the domestic market - by 1974.It was developed in Spain by SEAT, with which Italian company Fiat had signed an agreement of collaboration in the 1950s. Initially the 133 was only sold in Spain and did not enjoy great success, since it suffered from frequent overheating problems. It was intended to replace the old 600 and 850 models, and was also meant to provide a means for SEAT to open new markets and make up for the loss of sales in Spain that would come with the disappearance of the restrictions in car imports during the 1970s:[citation needed] it later enjoyed success in other parts of the world, such as Egypt for example, where the car is still in service.Reflecting the rear engine lay-out, there was just a small well for parcels behind the back seats, with more room for luggage under the 'bonnet/hood' at the front of the car.Up to 200,000 SEAT 133s had been produced by 1979 in Spain. A further 15,821 were made in the Fiat/Sevel Plant at Córdoba in Argentina between 1977 and 1982.In April 1977, it was announced that Egypt was about to become the world's 32nd car-producing country. This followed the signing of an agreement for the shipment of ckd kits from Seat's Barcelona plant to the Helwan premises of the Nasr Automotive Manufacturing Company for assembly, in order to supply the Egyptian market and for export to Iraq.The SEAT 133 was exported to Germany from the autumn/Fall of 1974: there it found some success among rear-wheel-drive loyalists in the mid-seventies. It was also sold in Britain from June 1975. These countries had no SEAT dealership network at the time, and the cars were branded as Fiat 133s, to be marketed alongside the Fiats 126 and 127.. }

• SEAT_133 abstract "The SEAT 133 was a small rear-engine car designed and sold by SEAT in Spain from 1974 to 1979. The car used the chassis and engine of the by then defunct Fiat/SEAT 850 and featured a new body in the style of the contemporary, somewhat smaller and only indirectly related Fiat 126.The car was first exhibited at the Barcelona Motor Show in May 1974. Noteworthy at that time was the compression ratio of only 8:1, which permitted the car to run on 85 octane petrol/gasoline. This was still appropriate in Spain, but elsewhere in western Europe even "regular" fuel grades by now generally guaranteed a higher minimum octane rating.The 133's design premise was that it had to be a cheap car both to develop and build. Thus, the final product inherited most of its components from the SEAT 850 (or very closely related Fiat 850). As with the 850, it was a rear-wheel drive, rear-engined car, a layout a that was being replaced by a trend for front-engined, front-wheel drive hatchbacks like the Renault 5 and Fiat's own Fiat 127.The 133 effectively replaced the SEAT 850 and the SEAT 600 both of which had been produced in considerable numbers with around 800,000 of the more venerable 600 built – almost exclusively for the domestic market - by 1974.It was developed in Spain by SEAT, with which Italian company Fiat had signed an agreement of collaboration in the 1950s. Initially the 133 was only sold in Spain and did not enjoy great success, since it suffered from frequent overheating problems. It was intended to replace the old 600 and 850 models, and was also meant to provide a means for SEAT to open new markets and make up for the loss of sales in Spain that would come with the disappearance of the restrictions in car imports during the 1970s:[citation needed] it later enjoyed success in other parts of the world, such as Egypt for example, where the car is still in service.Reflecting the rear engine lay-out, there was just a small well for parcels behind the back seats, with more room for luggage under the 'bonnet/hood' at the front of the car.Up to 200,000 SEAT 133s had been produced by 1979 in Spain. A further 15,821 were made in the Fiat/Sevel Plant at Córdoba in Argentina between 1977 and 1982.In April 1977, it was announced that Egypt was about to become the world's 32nd car-producing country. This followed the signing of an agreement for the shipment of ckd kits from Seat's Barcelona plant to the Helwan premises of the Nasr Automotive Manufacturing Company for assembly, in order to supply the Egyptian market and for export to Iraq.The SEAT 133 was exported to Germany from the autumn/Fall of 1974: there it found some success among rear-wheel-drive loyalists in the mid-seventies. It was also sold in Britain from June 1975. These countries had no SEAT dealership network at the time, and the cars were branded as Fiat 133s, to be marketed alongside the Fiats 126 and 127.".