Matches in DBpedia 2014 for { <http://dbpedia.org/resource/Falsing> ?p ?o. }
Showing items 1 to 19 of
19
with 100 items per page.
- Falsing abstract "In telecommunications, falsing describes a decoder assuming that it is detecting a valid input when one is not present. This is also known as a false decode. To make the concepts simpler, this article will discuss analog circuits used before digital signal processing.Examples of decoder falsing include: a telephone answering machine detecting dial pulses from a rotary dial as ringing voltage. The result being that the answering machine answers in response to dialing. a two-way radio with an enabled CTCSS decoder turns on the receive audio for one or two syllables of a signal with a close-in-tone-frequency (but wrong) CTCSS tone. The person listening to the radio occasionally hears nonsense partial words from the receiver's speaker: "et"... "up"... a ringy telephone circuit with SF single-frequency signaling and poor level discipline drops calls because it sees harmonic frequencies or the distorted waveform as a valid "circuit idle" or "on-hook" SF signal. power line transients cause a telemetry decoder to momentarily decode the power line noise as a false "turn-on" command, causing a remote-controlled water well pump to cycle on and off needlessly. Analog tone decoders used in telephone and two-way radio systems are designed to work in a balance between expensive, complicated filtering and low cost simplicity. The engineering problem is to make the simplest circuit that will work reliably. A decoder generally tries to filter audio input to strip off every audio component except a sought-after, specific tone. In part, a decoder is a narrow bandpass filter. A signal that gets through the narrow filter is rectified into a DC voltage which is used to switch something on or off.Falsing sometimes occurs on a voice circuit when a human voice hits the exact pitch to which the tone decoder is tuned, a condition called talk-off.For the tone decoder to work reliably, the audio input level must be in the linear range of audio stages, (undistorted). A 1,500 Hz tone fed into an amplifier that distorts the tone could produce a harmonic at 3,000 Hz, falsely triggering a decoder that is tuned to 3,000 Hz.".
- Falsing wikiPageID "6723290".
- Falsing wikiPageRevisionID "502703120".
- Falsing hasPhotoCollection Falsing.
- Falsing subject Category:Error.
- Falsing subject Category:Radio_technology.
- Falsing subject Category:Telephony_signals.
- Falsing type Abstraction100002137.
- Falsing type Communication100033020.
- Falsing type Signal106791372.
- Falsing type TelephonySignals.
- Falsing comment "In telecommunications, falsing describes a decoder assuming that it is detecting a valid input when one is not present. This is also known as a false decode. To make the concepts simpler, this article will discuss analog circuits used before digital signal processing.Examples of decoder falsing include: a telephone answering machine detecting dial pulses from a rotary dial as ringing voltage. The result being that the answering machine answers in response to dialing.".
- Falsing label "Falsing".
- Falsing sameAs m.0gkn4f.
- Falsing sameAs Q5432790.
- Falsing sameAs Q5432790.
- Falsing sameAs Falsing.
- Falsing wasDerivedFrom Falsing?oldid=502703120.
- Falsing isPrimaryTopicOf Falsing.