Matches in DBpedia 2014 for { <http://dbpedia.org/resource/Microwave_chemistry_sensor> ?p ?o. }
Showing items 1 to 23 of
23
with 100 items per page.
- Microwave_chemistry_sensor abstract "Microwave chemistry sensor or Surface acoustic wave (SAW) sensors consist of an input transducer, a chemically adsorbent polymer film, and an output transducer on a piezoelectric substrate, which is typically quartz. The input transducer launches an acoustic wave that travels through the chemical film and is detected by the output transducer. The Sandia-made device runs at a very high frequency (approximately 525 MHz), and the velocity and attenuation of the signal are sensitive to the viscoelasticity and mass of the thin film . SAWS have been able to distinguish organophosphates, chlorinated hydrocarbons, ketones, alcohols, aromatic hydrocarbons, saturated hydrocarbons, and water . The SAW used in these tests have four channels—each channel consists of a transmitter and a receiver, separated by a small distance. Three of the four channels have a polymer deposited on the substrate between the transmitter and receiver. The purpose of the polymers is to adsorb chemicals of interest, with different polymers having different affinities to various chemicals. When a chemical is adsorbed, the mass of the polymer increases, causing a slight change in phase of the acoustic signal relative to the reference (fourth) channel, which does not contain a polymer. The SAW device also contains three Application Specific Integrated Circuit chips (ASICs), which contain the electronics to analyze the signals and provide a DC voltage signal proportional to the phase shift. The SAW device, containing the transducers and ASICs, is bonded to a piece of quartz glass, which is placed in a leadless chip carrier (LCC). Wire bonds connect the terminals of the leadless chip carrier to the SAW circuits.".
- Microwave_chemistry_sensor wikiPageID "14230861".
- Microwave_chemistry_sensor wikiPageRevisionID "584520751".
- Microwave_chemistry_sensor hasPhotoCollection Microwave_chemistry_sensor.
- Microwave_chemistry_sensor subject Category:Analytical_chemistry.
- Microwave_chemistry_sensor subject Category:Microwave_chemistry.
- Microwave_chemistry_sensor subject Category:Sensors.
- Microwave_chemistry_sensor type Artifact100021939.
- Microwave_chemistry_sensor type Detector103180969.
- Microwave_chemistry_sensor type Device103183080.
- Microwave_chemistry_sensor type Instrumentality103575240.
- Microwave_chemistry_sensor type Object100002684.
- Microwave_chemistry_sensor type PhysicalEntity100001930.
- Microwave_chemistry_sensor type Sensors.
- Microwave_chemistry_sensor type Whole100003553.
- Microwave_chemistry_sensor comment "Microwave chemistry sensor or Surface acoustic wave (SAW) sensors consist of an input transducer, a chemically adsorbent polymer film, and an output transducer on a piezoelectric substrate, which is typically quartz. The input transducer launches an acoustic wave that travels through the chemical film and is detected by the output transducer.".
- Microwave_chemistry_sensor label "Microwave chemistry sensor".
- Microwave_chemistry_sensor sameAs m.03cyk43.
- Microwave_chemistry_sensor sameAs Q6840496.
- Microwave_chemistry_sensor sameAs Q6840496.
- Microwave_chemistry_sensor sameAs Microwave_chemistry_sensor.
- Microwave_chemistry_sensor wasDerivedFrom Microwave_chemistry_sensor?oldid=584520751.
- Microwave_chemistry_sensor isPrimaryTopicOf Microwave_chemistry_sensor.