Matches in DBpedia 2014 for { <http://dbpedia.org/resource/Patch_cable> ?p ?o. }
Showing items 1 to 25 of
25
with 100 items per page.
- Patch_cable abstract "A patch cable or patch cord or patch lead is an electrical or optical cable used to connect ("patch-in") one electronic or optical device to another for signal routing. Devices of different types (e.g., a switch connected to a computer, or a switch to a router) are connected with patch cords. Patch cords are usually produced in many different colors so as to be easily distinguishable, and are relatively short, perhaps no longer than two metres. Types of patch cords include microphone cables, headphone extension cables, XLR connector, Tiny Telephone (TT) connector, RCA connector and ¼" TRS phone connector cables (as well as modular Ethernet cables), and thicker, hose-like cords (snake cable) used to carry video or amplified signals. However, patch cords typically refer only to short cords used with patch panels.Patch cords can be as short as 3 inches (ca. 8 cm), to connect stacked components or route signals through a patch bay, or as long as twenty feet (ca. 6 m) or more in length for snake cables. As length increases, the cables are usually thicker and/or made with more shielding, to prevent signal loss (attenuation) and the introduction of unwanted radio frequencies and hum (electromagnetic interference).Patch cords are often made of coaxial cables, with the signal carried through a shielded core, and the electrical ground or earthed return connection carried through a wire mesh surrounding the core. Each end of the cable is attached to a connector so that the cord may be plugged in. Connector types may vary widely, particularly with adapting cables.Patch cords may be: Single-conductor wires using, for example, banana connectors Coaxial cables using, for example, BNC connectors Twisted pair Cat5, Cat5e, or Cat6 cables using 8P8C (RJ-45) modular connectors with T568A or T568B wiring Optical fiber cablesA patch cord is always fitted with connectors at both ends. A pigtail is similar to a patch cord and is the informal name given to a cable fitted with a connector at one end and bare wires (or bare fibre) at the other. The non-connectorized end ("the pigtail") is intended to be permanently attached to a component or terminal.".
- Patch_cable thumbnail Cat_5.jpg?width=300.
- Patch_cable wikiPageExternalLink 99-white-papers.
- Patch_cable wikiPageID "2336638".
- Patch_cable wikiPageRevisionID "591533473".
- Patch_cable hasPhotoCollection Patch_cable.
- Patch_cable subject Category:Networking_hardware.
- Patch_cable subject Category:Telephony_equipment.
- Patch_cable comment "A patch cable or patch cord or patch lead is an electrical or optical cable used to connect ("patch-in") one electronic or optical device to another for signal routing. Devices of different types (e.g., a switch connected to a computer, or a switch to a router) are connected with patch cords. Patch cords are usually produced in many different colors so as to be easily distinguishable, and are relatively short, perhaps no longer than two metres.".
- Patch_cable label "Kabel krosowy".
- Patch_cable label "Patch cable".
- Patch_cable label "Patch cable".
- Patch_cable label "Patch cord".
- Patch_cable label "Patchkabel".
- Patch_cable label "Коммутационный шнур".
- Patch_cable sameAs Patchkabel.
- Patch_cable sameAs Patch_cord.
- Patch_cable sameAs Kabel_krosowy.
- Patch_cable sameAs Patch_cable.
- Patch_cable sameAs m.074py6.
- Patch_cable sameAs Q39186.
- Patch_cable sameAs Q39186.
- Patch_cable wasDerivedFrom Patch_cable?oldid=591533473.
- Patch_cable depiction Cat_5.jpg.
- Patch_cable isPrimaryTopicOf Patch_cable.
